The main motor is located just to the left of the toner cartridge. Go to Small Business. Check the TMC pin in the cartridge contact error for free non binding movement If pin does not move freely you may need to replace the contact assembly. Printhead Error – May have sub-codes. Los Altos Hills, CA. The exit sensor was not made in time after the input sensor as made. If the paper is jammed in the rear of the duplex, replace the duplex front cover and open the duplex rear door.
|Date Added:||17 September 2004|
|File Size:||31.21 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Open lemark and covers and remove the toner cartridge. May require service technician Press “GO” to clear message and temporarily continue. The Transfer drum has reached the end lexmark optra se 3455 it’s life and must be replaced. A service error indicates the wrong fuser lamp is installed in the printer and does not match the one stored in the printer code.
The main motor is located just to the left lexmark optra se 3455 the toner cartridge. It may take the printer seconds to determine if the print cartridge is defective. Check for 24V at red wire on interlock switch with door closed 4.
404 Not Found
It can also be lexmark optra se 3455 LVPS low voltage power supply or a fuse in the power supply on some models. Los Altos Hills, CA. Replacement of the thermistor is not a cost effective repair, replace fuser assembly. Disk Full Not enough disk space for data that has been requested to be written to disk. Observe the lamp through the left near side of the otpra.
Remove the duplex front cover to access the jam area. Open the printer rear door to access the jam. Fuser Lezmark – Problem in the fuser, not heating, heating to quickly or too hot. Check the fuser lamp is the correct lexmark optra se 3455 of lamp that should be installed.
Lexmark Printer Drivers
Paper is either not leaving the duplex entry sensor in time or not making or unmaking the lexmark optra se 3455 exit sensor in time. Font card format not supported by printer. Serial Error – Framing or parity error on serial.
If the error appeared while sending a job from the host to the printer, turn the printer off, then turn it on and try again. Replace bump motor Replace interlock switch Replace System Card. Pay close attention to the area where the lexmark optra se 3455 cartridge sits.
Replace the Autocompensator Assy. May be due to the paper feeding manually while motors running and previous page in path. Replace Fuser Lexmark Fuser. If pin does not move freely lexmark optra se 3455 may need to replace the contact assembly.
Network Card Codes These user codes are documented in various network card user manuals. Replace the bump alignment motor. The transfer roller is included in the maintenance kit. Additional info on X and XX codes available by email. The fuser can usually be removed with two simple screws and the entire assembly lifted lexmark optra se 3455. Small and Medium Business. Check the integrated paper tray, tray 1, for paper loading problems.
I truly appreciate it. Replace System Lexmark optra se 3455 Request Quote. No inkjet error codes available Error Code. Genuine Lexmark Supplies deliver ee image quality, while also producing higher volumes and reducing cost per page. Duplex Cover Open Top cover of duplex unit is sensed open. Duplex Not Attached Duplex is electrically connected but no longer mechanically attached, and printer top cover is closed.
Input sensor not made after pick attempt.